Video Lecture Series from IIT Professors :Pulse width Modulation for Power Electronic Converters by Dr. G. Narayanan sir
Room No: 234 First Floor
Power Electronics Group Department of Electrical Engineering Indian Institute of Science, Bangalore
|2000||Ph.D.||Indian Institute of Science, Bangalore|
|1994||M.Tech.||Indian Institute of Technology, Kharagpur|
|1992||B.E.||College of Engineering, Guindy, Anna University, Chennai|
Converter topologies for AC/DC and DC/AC power conversion, overview of applications of voltage source converters; pulsewidth modulation techniques for 1-phase and 3-phase bridge converters, sine-triangle PWM, bus clamping PWM, space vector based PWM, advanced PWM techniques; calculation of switching and conduction losses; compensation for dead time and DC voltage regulation; estimation of current ripple and torque ripple in inverter fed drives; overmodulation; extension of modulation methods to multilevel inverters.
Power electronic converters for dc-ac and ac-dc power conversion (6 lectures).
Electronic switches, dc-dc buck and boost converters, H-bridge, multilevel converters – diode clamp, flying capacitor and cascaded-cell converters; voltage source and current source converters; evolution of topologies for dc-ac power conversion from dc-dc converters.
Applications of voltage source converters (2 lectures).
Overview of applications of voltage source converter, motor drives, active front-end converters, reactive compensators, active power filters
Purpose of pulsewidth modulation (2 lectures).
Review of Fourier series, fundamental and harmonic voltages; machine model for harmonic voltages; undesirable effects of harmonic voltages – line current distortion, increased losses, pulsating torque in motor drives; control of fundamental voltage; mitigation of harmonics and their adverse effects
Pulsewidth modulation (PWM) at low switching frequency (3 lectures).
Square wave operation of voltage source inverter, PWM with a few switching angles per quarter cycle, equal voltage contours, selective harmonic elimination, THD optimized PWM, off-line PWM
Triangle-comparison based PWM (4 lectures).
Average pole voltages, sinusoidal modulation, third harmonic injection, continuous PWM, bus-clamping or discontinuous PWM
Space vector based PWM (4 lectures).
Space vector concept and transformation, per-phase methods from a space vector perspective, space vector based modulation, conventional space vector PWM, bus-clamping PWM, advanced PWM, triangle-comparison approach versus space vector approach to PWM
Analysis of line current ripple (4 lectures).
Synchronously revolving reference frame; error between reference voltage and applied voltage, integral of voltage error; evaluation of line current ripple; hybrid PWM for reduced line current ripple
Analysis of dc link current (2 lectures).
Relation between line-side currents and dc link current; dc link current and inverter state; rms dc current ripple over a carrier cycle; rms current rating of dc capacitors
Analysis of torque ripple (2 lectures).
Evaluation of harmonic torques and rms torque ripple, hybrid PWM for reduced torque ripple
Inverter loss (3 lectures).
Simplifying assumptions in evaluation of inverter loss, dependence of inverter loss on line power factor, influence of PWM techniques on switching loss, design of PWM for low inverter loss.
Effect of inverter dead-time effect (2 lectures).
Requirement of dead-time, effect of dead-time on line voltages, dependence on power factor and modulation method, compensation of dead-time effect.
Overmodulation (3 lectures).
Per-phase and space vector approaches to overmodulation, average voltages in a synchronously revolving d-q reference frame, low-frequency harmonic distortion
PWM for multilevel inverter (3 lectures).
Extensions of sine-triangle PWM to multilevel inverters, voltage space vectors, space vector based PWM, analysis of line current ripple and torque ripple
Lecture schedule – Pulsewidth Modulation for Power Electronic Converters